HERKULES GW/R-2-T, Руководство пользователя

Страница: 12 / 19

Diaphragm pump housing assembly instructions
1 Place the two nylon spacers over the housing bolts 3 Tighten the diaphragm pump housing to the
and insert into the gun washer frame holes. Place upper stand.
flat washer, then lock washer, then nut onto the 1”
bolt and finger tighten.
4 Connect air tubing between pump housing
and lid valve bracket.
Note: The timer knob is at the front of the housing
and the air tubing lines are at the rear.
a. Connect the blue plastic air tubing running
from the air cut off switch on the pump housing
2 Connect the two metal solvent tubes between the to the in port of the air cut off switch on the lid
pump and the tub. valve bracket. See drawings pages 12-13. The
hose must bottom out in the switch. Pull firmly
Note: Some adjustment of the pump fittings may be
to test for tight connection.
necessary.
b. Connect the black plastic air tubing running
a. Connect the 3/8” diameter tube between the from the pump housing to the out port of the
“Material Outlet” of the pump and the top outlet of air cut off switch on the lid valve bracket. See
the tub. Finger tighten. drawings pages 12-13. Again the hose must
bottom out in the switch. Pull firmly to test for
b. Connect the 1/2” diameter tube between the
tight connection
“Material Inlet” of the pump and the lower outlet of
the tub. Some alignment may be necessary for
proper fitting of all four flare connections. Finger
tighten.
c. When the housing and the solvent tubes are
aligned, tighten the four flare nuts.
Note: When tightening the 1/2” solvent tube, use
a 13/16” open end wrench to hold the flare
fitting in the pump while tightening the 7/8”
flare nut on the solvent tube. This will prevent
pump damage when tightening.
Air cut off switch
OUT PORT
01981000(13)
IN PORT
Lid Valve Bracket Assembly
#M1SA
Page 12 of 19