Herkules Hebetechnik GmbH HLS 1200-13, Руководство по эксплуатации и журнал испытаний

Страница: 22 / 39

O
PERATION
22
9.2 Commissioning
Read the following functional checklist before using the service lift:
•
Make sure that no persons or objects are present in the area of operation of the service lift.
•
Secure the compressed air supply.
•
Open the main tap on the operating control unit.
•
Confirm that the operating control unit switch is in the lifting position - 'lift' until the service lift reaches
the upper end limit.
•
Confirm that the operating control unit switch is in the lowering position - 'lower' until the service lift
reaches the lower end limit.
•
Repeat lifting and lowering movements several times without load.
•
The safety catch should lock into place at the end of each lift movement or in the intermediate
position on both sides in the gear teeth.
Observe the operating instructions for the respective work places on the service lift. Only the operating
personnel may stand in the vicinity of the service lift while in use.
Also read the
Chapter "General Safety Instructions"
.
9.3 Description of safety catch
•
During lifting the safety catch is swivelled down. The catches of the safety catch slide on both sides of
the detents of the inner scissoring. After the lifting motion the safety catch should be fully engaged on
both sides to ensure safety.
Diagram 4 / 5: safety catch engaged / safety catch lifted during lowering operation
•
The safety catch is lifted up by means of the cylinder during lowering movement. At the end of the
lowering movement or by interruption of the movement, the safety catch automatically drops and
thereby grips into the detents of the service lift.
Should the service lift not lower:
In this case briefly lift the service lift until the drop is free. Afterwards repeat the
lowering movement.