Installation
Basin and Bidet Mixer
1. Identify all components are present prior to starting installation.
2. Screw in copper pipes (19) and fixing kit rod (15) to tap. Fit the mixer body to the basin/bidet
using the ‘C’ plate fixing kit. The full rubber washer (12) goes between the fitting and the
basin/bidet, and the ‘C’ shaped rubber (13) and metal washer (14) on the underside of the
basin/bidet, to be secured by the threaded tail and backnut (15).
3. Connect the hot and cold supplies. DO NOT OVERTIGHTEN. Soft copper tails can be carefully
bent and cut to length to meet supply pipes.
4. Fit the pop-up waste, with the flat washer below and the shaped washer above the basin/bidet. It
is recommended that a silicon sealant be applied to both sealing faces of washers. The plug
height can be set by adjusting the waste rod (17) and operating rod (10) connecting bracket
(18), and the screw in the base of the plug. If the plug will not stay closed, the friction of the pop
up mechanism can be increased by tightening the nut.
5. Fully open both valves, letting them run for a few minutes to flush out the system and check all
joints and connections for leaks.
11.
Mixer Body
x1
12.
Washer
x1
13.
C-Shaped Rubber Plate
x1
14.
C-Shaped Metal Plate
x1
15.
Threaded Tail & Backnut
x1
16.
Waste Assembly
x1
17.
Horizontal Waste Rod
x1
18.
Pop Up Link
x1
19.
Connecting Pipes
x2
1.
Indice
x2
2.
Grub Screw
x2
3.
Metal Washer
x2
4.
Handle
x2
5.
Shroud
x2
6.
Washer
x2
7.
Valve
x2
8.
Anti-Splash Assembly
x1
9.
Pop Up Knob
x1
10.
Pop-Up Rod
x1
05
