hergom E-30M, Инструкции по установке, использованию и обслуживанию

Страница: 17 / 40

HANDLE
FIG. 5
4 - LIGHTING UP AND USE
It is very important that the first time the heater is
lit, it is done so slowly.
This is for the following reasons:
• Stabilise cast iron parts.
• Harden the joint sealant putty.
Advise:
• We recommend that the first loads of fuel be
small.
• To generate draw, heat the chimney by
introducing some burning paper in the gap
between the front and the deflector, directing
it toward the chimney.
• While lighting for the first time, ensure the room
where the heater is located is well ventilated as
the paint work may let off some fumes.
• Keep the stove on for a few hours at this
intensity.
• IMPORTANT! The total height of the fire load
should not exceed 50% of the height of the
combustion chamber.
• The heater must be closed at all times during
combustion to prevent smoke from leaking
out. Only open to add fuel.
Daily use
After lighting up for the first time, your heater will
be ready for daily use
.
Your heat requirements will be obtained based on
the frequency and the amount of firewood you
load.
When your heater is cold, we recommend lighting
it up slowly.
Overheating.
Overheating means that you have operated
your heater at a excessively high temperatures
for a long period of time. This can damage your
appliance and, therefore, it is a situation that must
be avoided.
Overheating is the result of excessive draw, due to
any of the following reasons:
• The Primary Air Valve is excessively open for
the type of wood being used.
• The chimney is too big.
• Improper maintenance of the stove, which may
result in air infiltration.
• Inappropriate fuel that produces high
temperatures.
• Door not closed correctly.
ATTENTION!
During operation of the heater, the ash pan door
should remain closed.
Any uncontrolled intake of air produces overheating
that can damage the stove.
HEATERS WITH ENAMEL IN MAJOLICA
VERY IMPORTANT!
In the case of stoves enamelled in Majolica, it is
normal for slight fissures to appear in the glazing,
providing the product with its characteristic
appearance, once the heater is lit.
However, in the event of uncontrolled overheating,
these fissures caused by the different expansion
levels of the cast iron and the Majolica enamel
with vitreous components, can cause the enamel
to chip.
To avoid this inconvenience, control combustion
and never overheat the heater.
INDUSTRIAS HERGÓM S.A. may not be held liable
for the deterioration of the stove’s enamel if these
instructions are not followed.