HENX A40LJ14B01, Руководство оператора

Страница: 37 / 77

37
3. Position the chain saw on its side
on a firm,flat surface, so that the
tank cap is facing upwards.
Rotate the oil tank cap
counterclockwise to remove it
(Fig. 8).
4. Carefully pour the bar and
chain oil into the tank. The
filter in the opening allows the
oil to seep slowly into the
tank; be careful not to let the
oil spill from the opening. Fill
to the bottom of the fill neck.
Wipe off any excess oil.
5. Replace the cap, place the saw upright, and view the level through
the oil inspection window. Oil should fill the window.
NOTICE:
◾
Use Oregon Chain and Bar oil for best results. It is specially designed to
provide low friction and faster cuts.
◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature
wear of the bar and chain.
◾
Check the oil level frequently and fill when the oil level falls below the minimum
line. Never operate the chain saw if the oil is not visible.
◾
Do not use dirty, used or otherwise contaminated oils. Damage may occur to the
bar or chain.
◾
There is a filter inserted in the opening of the oil tank to filter out dirt and debris.
DO NOT remove the filter when filling the oil tank.
Oil Tank Cap
8