Henseleit Helicopters Three-Dee-Fun TDR-II, Руководство пользователя

Страница: 35 / 67

35
S w a s h p l a t e l i n k a g e
(Assembly group 6)
0650a Ball link 19mm 6
0650c Stud bolt M2,5x33 3
Screw respectively 2 ball ends 0650a on the three thread rods
0650.
The distances
„
X
“ are depending from the position of the tooth
rack, which level can vary do to the servo type used. Adjust a
length of 13mm on all control rods at first.
Press the
control rods with the characters “2,5” facing outside
on the ball pins of the tooth rack.
Attention! The outer ring of the swashplate has to be tilted so
that the special ball pin with the slim cylindrical shaft is facing
backwards towards the elevator servo (left upper picture). Align
roughly by visual judgement. The fixation will be done later on
by the swashplate guide (see next page).
Center the three swashplate servos in neutral position (center
of the collective stick). You can do in the same manner as for
the mounting of the servo gear or you can connect the servos
to your FBL system and adjust the servos to neutral position in
e.g. the setup menu.
Adjust the length of the control rods until the swashplate is in a
horizontal position and the upper side of the swashplate
bearing face is align with the upper edge of the bracket of the
guide rail. (see
red line
in the pictures for the different axis’s).
These three upper edges build the reference level (see also
yellow arrow ) so there is no need for a gauge for the
swashplate adjustment.
When this basis adjustment is done properly the two blade
grips stand at a 0° angle (
yellow line in picture left). Fine
corrections can be done at the control rods between
swashplate and blade grips.