Henseleit Helicopters Three-Dee-Fun TDR-II, Руководство пользователя

Страница: 25 / 67

25
C h a s s i s m o u n t
The two chassis plates will now be
connected with the two bearing plates.
Check with the drawing which screws
will be placed in which holes.
Use a M3x8 lens head screw at the front
and a M3x8 Allen screw at the rear of
the upper bearing plate. The center hole
remains unused.
Use three M3x8 Allen screws for the
lower plate on each side. The third hole
counted from front remains unused.
Torque
the screws carefully and
alternating to prevent tensioning of the
chassis.
There is no need to use
L octite for these
screws as the screws are under tension
during operation and will not get loose.
The rear (higher) X-stiffener 0208 will be screwed at all
four corners with M3x6 Allen screws directly to the upper
and lower bearing plates (picture left).
(use some
L octite at this position).
The front (shorter) X-stiffener 0207 will be screwed with
two fitting blocks 0206 (picture left below).
Take care to align the blocks parallel to each other.
Position the X-stiffener on an even plate and press down
the two blocks with two fingers while tightening the two
M3x8 Allen screws.
Slide the X-stiffener with the two blocks facing
downwards and forward between the two chassis plates.
Screw them with M3x8 screws to the already mounted
blocks at the upper bearing plate and with M3x12 screws
to the upper side of the lower bearing plate (use
L octite).