Important: Always read and follow instructions. • 7
Figure 6 - Loosen the bolts and move BACK PLATE upward
against the chassis edge,then tighten them.
6.
Place PEDAL BOX ASSY to the right orientation as
(fig 7) shown and connect tubes by color,(black tube to
black fitting and clear tube to the plain plated fitting).
Figure 7 - Connect tubes
7.
Lay PEDAL BOX ASSY between chassis and the
LIFT ASSY, Route the INLET LEADER HOSE out of the
rear corner.Slide the PEDAL BOX ASSY back against
the rear wall of the BASE TRACK
as shown ( fig
8), tighen the (2) bolts.
Figure 8 - Bolt PEDAL BOX ASSY to BASE TRACK
8.
Remove the bolt to let WHEEL TRAY move free
(fig 9)
Figure 9 - Remove the bolt
9.
Insert rear WHEEL RAMP lip into the slot of BASE
TRACK (fig 10).
Figure 10 - Setup RAMP
10.
Prepare the hose fitting 1/4-NPT (NOT SUP-
PLIED) for connection to the main air supply (fig 11).
Figure 11 - Prepare the fitting [Customer-supplied]
11.
Connect to air supply. Actuate VALVE PEDAL to
and move the WHEEL TRAY up and down two or three
times with the WHEEL TRAY unloaded.
Important:
It is normal if the Tire Lift jumps 2 or 3
inches the first time it lifts after air has been applied.
