6 • Important: Always read and follow instructions.
Installation
Pneumatic Connection
Connect air intake to a compressed air system with
a working pressure of 120-150 PSI. Use a compressed
air hose with an inside diameter of 1/4” - 3/8”.
Make sure air hose is free of the BASE
TRACK area. If the air hose is damaged, the
Tire Lift may descend unexpectedly.
Assembly Instructions
Tools Required:
• Marker
• Tape or Ruler
• 13-mm Socket
• 13-mm Spanner
• 3/8-in Socket
• Ratchet
• Claw Hammer
• Customer supplied fitting
525 Light Duty Tire Lift Components:
• PEDAL BOX ASSY (1,9)
• BACK PLATE ASSY (2)
• LIFT ASSY (3,4,6,7,8)
• WHEEL RAMP (5)
1.
Position unit by the wheel balancer;
unpack the box as (fig 2) shown, and remove
all side walls
Figure 2 - Unpack the box remove all side walls.
2.
Remove 2 screws as (fig 3) shown, then slide the
PEDAL BOX ASSY along the direction as the arrow
showing to disenagage from the BASE TRACK. Put it
aside,and then put WHEEL RAMP aside for later use.
Figure 3 - Remove 2 screws and slide the PEDAL BOX ASSY
as shown by arrow.
3.
Remove 2 screws (fig 4)and move LIFT ASSY below
the Balancer stub shaft.
Figure 4 - 2 screws
4.
Slide LIFT ASSY so the BASE TRACK is up against
the wheel balancer chassis;below the stub shaft. With
the aid of a tape measure,place the BASE TRACK
2.8-inches from the balancer edge as shown (fig 5)
Figure 5 - Position LIFT ASSY against Wheel Balancer
5.
Loosen the 2 bolts, lift the BACK PLATE upward
until the bolt is against the chassis edge( fig 6),and then
tighten the bolts.
