Henkel Loctite EQ PR10.1 DLP, Руководство по эксплуатации

Страница: 36 / 42

36
Be careful when using the scraper as not to slip and injure yourself
Take care when using the scraper so you do not damage the build platform.
Ensure the scraper is used with the beveled face upwards.
7.5 Cleaning the Build Platform
1. Wipe any excess resin away with a paper towel
2. Use the supplied plastic scraper to remove any cured resin on the build platform.
3. Wipe the build platform with a paper towel
4. Wet the build platform with Isopropanol Alcohol (IPA)
5. Use the supplied plastic scraper to scrape the build platform again
6. Wipe the build platform to remove any remaining resin.
Always wear gloves and safety glasses when handling resin or IPA
7.6 Cleaning the Basin
1. Remove the two pins holding the resin basin to the frame of the printer
2. Carefully remove the resin basin, keeping it as level as possible while doing so
3. Pour the resin back into the container using a funnel. Use a filter to remove any
contamination.
4. Spray the resin basin with Isopropanol Alcohol (IPA) and gently wipe residual resin
away with a paper towel.
5. Ensure the basin is clean before re-using.
Always wear gloves and safety glasses when handling resin or IPA
Do not rub the bottom of the basin to clean it. This will damage the basin.
Do not place the resin bottom flat on a surface. Always place a paper towel underneath the
glass.