Henkel AQC-XH, Руководство пользователя

Страница: 15 / 38

SAFETY
Lift Groups Safety Section 1-11
© 2009 Alamo Group Inc.
SAFETY
Use proper protective equipment including gloves, safety eye wear, arm protection when
handling plow blades and components during replacement, adjustment, and maintenance.
Plow edges and components can become sharp and have burrs that could inflict puncture
and cuts to the hands, arms, and/or eyes if proper protective equipment is not worn.
(SNPM-08)
Replace bent, cracked, or broken plow blade with a new blade. Ne ver attempt to
straighten or weld on plow blades because this will likely crack or otherwise damage the
blade with subsequent failure and possible serious injury from broken blade being ejected
from plow.
(SNPM-10)
Escaping pressurized hydraulic oil generated by hydr aulic pumps has the potential to
inflict serious injury and possible death. Never attempt to repair a pump or hose or tighten
a connection while the system is pre ssurized. Always shu t down the engine and relieve
hydraulic oil pressure before performing any repairs to the hydraulic system.
(SNPM-11)
Hydraulic pressure must be relieved from the hydraulic circuit prior to d oing any
maintenance or repair work and when the Snow Plow is parked at the end of the day.
Place the Snow Plow(s) on the ground or securely blocked up. Turn off the Truck engine
then engage the hydraulic remote cylinders several times to relieve hydraulic pressure
prior to performing any maintenance or repair work.
(SNPM-12)
Never remove debris from or unclog jams in the plow or lifting components until the engine
have been completely shutdown and all components have come to a comp lete stop and
are lowered to g round level and hydraulic pressure relieved. Always wear PPE when
removing collected material and debris from the equipment. Serious injury or death may
occur if any of these precautions are not followed when removing plugged or entangled
debris.
(SNPM-15)
Engine Exhaust, some of its constituents, and certain vehicle components contain or emit
chemicals known to the state of California to cause cancer and birth defects or other
reproductive harm.
(SNPM-20)
Do not operate this equipment with hydraulic oil or fu el
leaking. Oil and fuel are expensive and their presence
could present a hazard. Do not check for leaks with your
hand! High-pressure oil streams from breaks in the line
could penetrate the skin and cause tissue damage including
gangrene. To check for a hose leak, SHUT the ENGINE OFF and
remove all hydraulic pressure. Wear oil impenetrable gloves, safety
glasses and use Cardboard to check for evidence of oil leaks. If you
suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated
immediately by a physician knowledgeable and skilled in
this procedure.
(SNPM-21)
Always read carefully and fully comply with the manufacturers instructions when handling
fuels, oils, solvents, cleansers, and any other chemical agent.
(SNPM-22)