Hengstler C-56, Руководство оператора

Страница: 13 / 17

Thermal Printer C-56
Part No. 2 684 019 Rev. No. 4310715 eli page
13
of
17
5.2 Replacement of Components
The C-56 thermal printer does not require any servicing. It has been designed such that its main modules
represented in the illustration below can be replaced also by the operational staff after short briefing, within less
than 2 minutes. The modules do not require any adjustment. Note that additional care must be taken concerning
wire routing if the optional chute sensor or hardware paper-low sensor are installed.
Fig. 7 Modular structure of the C-56 thermal printer with 4 main components
The eject chute is pushed into the guiding supports on the basic unit and cannot be removed when the printer
mechanism is installed. It represents the only access to the printer for the customer. The hinge pins are inserted
into the collars onto the basic unit in the sense illustrated above and then are pushed against the tilt position.
Only in this position, the printer mechanism can be placed onto the basic unit, and when the hinge pins are
snapped into the operating position, the printer will be locked on the basic unit. The two holes on the front of the
basic unit serve for installing the C-56 thermal printer in vending applications etc.