12
EN
10. AIR SWITCH INSTALLATION
1. Drill a 33 mm wide hole into the kitchen work
top, or the corner of the sinkunit, at the most
convenient point for use. Some sink units may
already have a suitable hole in them which can
be exposed by removing the cap.
2. Remove the nut from the push button bellows,
while keeping the rubber gasket in place. (See
Figure 10A)
10A
3. Push one end of the PVC tubing onto the spout
of the push button bellows, feed the other end
of the tube through the hole in the work top and
through the nut underneath the worktop. (See
Figure 10B)
10B
4. Fit the push button bellows in the hole (See Fig-
ure 10C)
33
10C
5. Screw up the nut underneaththe work top until it
is hand tight.
Do not use a wrench to tighten the
nut.
(See Figure 10D)
10D
6. Take the other end of the air tube and fi rmly
push it over the spout of the airswitch, which is
located on the underside of the waste disposer.
(See Figure 10E)
10E
