8
GB
Remark:
The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations
Spare parts or accessories
(Fig.2 on page 3)
1. Small
2. Medium
3. Large
Circuit diagram
(Fig.3 on page 4)
1. Temperature limiter
2. On / Off switch
3. Power input
4. Capacitor
Exploded diagram with part list
(Fig.4 on page 4)
Part no.
Part name
Quantity
1
Outer-cone
1
2
Inner-cone
1
3
Cone
1
4
Pip-filter
1
5
Stainless Steel Juice Bowl
1
6
Seal ring 11.8×1.8
1
7
Connect shaft
1
8
Buckler
1
9
Washer12×1.5
1
10
Rubber loop
1
11
Hollow cylinder
1
12
Seal ring 9.5×1.8
1
13
Big bearing seat
1
14
Motor
1
15
Wire holder
2
16
Cooler
1
17
Spring Washer 6
1
18
Nut M6
1
19
Motor housing
1
20
Cup seat
1
21
Switch
1
22
Washer 4
8
23
Spring Washer 4
8
24
Bolt M4×12
3
25
Bolt M4×8
3
26
Bolt M4×28
2
27
Capacitance
1
28
Capacitance holder
1
29
Power cord
1
30
Plug
1
31
Cord holder
1
32
Base board
1
33
Foot
4
34
Bolt M4×20 with washer
4
35
Underlay
1
36
Bolt M4 x 12 with washer
1
37
Plastic cover
1
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See == >
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE!
Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
•
CAUTION!
Please make sure the switch is on the “0” position
before plug in.
• Carefully clean citrus fruits before squeezing them.
• Cut the fruits to be squeezed into two halves.
• Place a suitable size of the pressing cone match with the fruit
on the appliance.
• Switch on the appliance by turning the switch to the “I” po-
sition.
• Squeeze the fruit halves.
• Switch off the appliance by turning the switch to the “0” posi-
tion after finish operation.
Thermal protection
This juicer is protected by a built-in thermal cut-out. In the
event of overheating, the motor will stop.
To reset, follow these steps.
• Set the On / Off switch to “Off”, and disconnect the plug
• Wait until the motor cools (20-45 minutes), reconnect the
plug, then press the On / Off switch again. If the problem
persists, remove the plug from the socket, and contact your
supplier.
Содержание 221204
