Henderson EVOLVE POCKET DOOR PRO Series, Инструкция по монтажу

Страница: 14 / 19

14
General Safety Precautions

This installation is intended for professionally competent personnel only.

Installation, electrical connections and adjustments must be performed in accordance with good working methods and in compliance with
applicable regulations. Before installing the product, carefully read the instructions. Bad installation could be hazardous.

The packaging material (plastic, polystyrene, etc.) should not be discarded in the environment or left with reach of children, as these are a
potential source of hazard.

Before installing the product, make sure it is in perfect condition.

Do not install the product in an explosive environment and atmosphere; gas or inflammable fumes are a serious risk hazard. Before
installing the system, ensure all structural changes relating to safety clearances and protection or segregation of all areas where there is a
risk of being crushed, cut or dragged, and danger areas in general.

Make sure the existing structure is up to standard in terms of the motorised door.

Apply hazard area notices required by application regulations.

The electricity supply must be isolated at its source before attempting installation or maintenance.
Disclaimer
P C Henderson, nor the motor unit manufacturer, take any responsibility for failure to use good working methods in building the frames to be
motorised or for any deformation occurring during use. P C Henderson and the motor unit manufacturer declines all responsibility in the event
of component parts being fitted that are not compatible with safe and correct operation.
For repairs or replacement of products - only original spare parts must be used.
Installer Responsibility
The installer should provide technical documentation once the installation is complete.

EC declaration of conformity with machinery directive

Installation manual

Maintenance / Trouble shooting guide (supplied in the drive unit manufacturer operation manual)

The installer is responsible for affixing final CE mark upon the installation
Manufacturer’s Declaration of Incorporation
Manufacturer:
PC Henderson, Durham Road, Bowburn, Co. Durham, DH6 5NG
Telephone: 0191 3770701
Fax: 0191 3771309
Hereby declares that the electromechanical automatic door operating system.
EVOLVE POCKET DOOR PRO
Are intended to be incorporated into machinery or to be assembled with other machinery to constitute machinery covered by directive
2006/42/EC.
It is in conformity with the provisions of the following directives.

Electromagnetic directive 2004/108/EC

Low voltage directive 2006/95/EC
The partly completed machinery must not be put into service until the final machinery into which it is to be incorporated has been declared in
conformity with the provisions of this Directive, where appropriate.
The technical file is maintained at:
PC Henderson Ltd, Durham Road, Bowburn, Co. Durham, DH6 5NG
Please Note
The original language of these instructions is English.
The airborne noise of the system under normal operating conditions does not exceed 70dB (A).