Helmer Scientific Cart and Pedestal
User Guide
360382/B
5
Installing Cart
1. Position cart in an open area.
2. Using a #2 Phillips screwdriver, remove the six screws securing the back panel of the cart (Figure 2).
Figure 2
3. Using two people to lift, carefully place the refrigerator on the cart aligning the 4 threaded holes located where the
leveling feet were with the four open holes on the top of the cart. The refrigerator should be flush with the cart on all sides
(Figure 3).
Figure 3
4. Place a washer on each M6 screw (4) provided. Reaching through the back panel opening, hand screw an M6 with
washer through each hole in the cart and into the threaded locations on the bottom of the refrigerator. Tighten screws
using a 10 mm wrench or adjustable wrench (Figure 4).
Figure 4
5. Replace the back panel of the cart by aligning the holes in the panel with the holes in the back of the cart. Hand thread
the 6 screws and tighten using a #2 Phillips screwdriver.
6. Restore moveable items (shelves, probe bottle, probe(s)) inside the unit to original state.
7. Plug power cord into power receptacle and turn AC power ON.
8. Allow chamber temperature to stabilize at setpoint prior to returning items to unit.
