Description of Component Parts
TMG Monitor
RIKEN OPTECH CORPORATION
ON/OFF
INSTRUMENT CO., INC.
MAUMEE, OHIO U.S.A.
B.C RESET
SAMPLING
ADAPTIVE/TREND
P.C SELECT
P.C SELECT
SETUP
SETUP DIAL
CONTRAST
RESET
ADAPTIVE/TREND
ON/OFF
ADAPTIVE
+ 0 0
+ 0 0
BATCH C
321
PRESET COUNTER
87654321
R.P.M
1000
PARTS COUNTER
87654321
ADAPTIVE
ADAPTIVE
TIMING
SAMPLING
14
19
15
16
17
20
5
9
8
7
6
11
11
12
13
10
4
1
2
14
18
3
1. Deviation display (unit: µm) - Displays the deviation detected by the proximity sensor. It is
factory set for adaptive (
mean value
) display.
2. Set point display - Displays the monitoring range between the upper and lower limits. When
the display shows a deviation exceeding the limit values, the TMG-1200 displays a fault
condition.
3. Bar display – Displays the deviation from the set point. The left side of the bar display is the
“-“ (negative) side of the set point and the right side the “+” (positive) side. The center square
is the “0” position, and the two sides are divided each into five equal parts. For example,
when the set point is 10, the display is as shown below:
-10 -8 -6 -4 -2 0 +2 +4 +6 +8 +10
Bar Display Scale (Unit: µm)
When the set point is less than 5, the display will show 5.
The bar display during set point setting serves as a clearance gauge to indicate the FDC
position (refer to section “Sensor Adjustment”).
Page 3
TMG-1200 Instruction Manual
