•
Do not use near or point the heater towards furniture, animals, curtains or other flammable objects.
Keep combustible materials such as furniture, bedding and curtains etc at least 1 metre from the
front, sides and rear of the heater.
•
Do not place the cord under carpet or cover with throw rugs or furniture. Arrange the cord so that it
cannot be tripped over.
•
Switch off and unplug from the power outlet when not in use, before assembly or disassembling
parts and before cleaning. Remove by grasping the plug – do not pull on the cord.
•
A common cause of overheating is deposits of fluff and dust entering the heater. Ensure these
deposits are removed regularly by unplugging the heater, allowing it to cool and clean as described
in the cleaning and maintenance section.
•
This Heater must be hung on the wall, with the wind outlet pointing down.
•
Ensure that no other high wattage appliances are plugged into the same power outlet as the Heater,
as an overload can occur.
•
Avoid the use of an extension cord, as the extension cord may overheat and cause a risk of fire.
•
Do not use the appliance other than for its intended use.
•
Do not use outdoors. FOR INDOOR USE ONLY.
•
Do not leave the appliance unattended while switched on.
•
Do not place objects on the product or allow objects to obstruct the inlet or outlet openings, or
operate in close proximity to walls or curtains, etc. Do not cover the unit when in operation.
•
Do not install in bathrooms, laundries or other ‘wet areas’ otherwise warranty will be voided.
•
Do no locate the Heater immediately below a power outlet.
•
The use of attachments or accessories not recommended or sold by the manufacturer or sold by the
product distributor may cause personal or property hazards or injuries.
•
This product is intended for normal domestic/household use only.
•
Use this Heater as described in this manual. Any other uses not recommended by the manufacturer,
may cause fire, electric shock, or injury to persons and may void the warranty.
•
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or connected
to a circuit that is regularly switched on and off by the utility.
•
The installation of a residual current device (safety switch) is recommended to provide additional
safety protection when using electrical appliances. It is advisable that a safety switch with a rated
residual operating current not exceeding 30mA be installed in the electrical circuit supplying the
appliance. See your electrician for professional advice.
Installing the Appliance
The Heater must be mounted at least 1.8m above the floor, and not directly below a power outlet. Mark
two holes on the wall as per the below diagram: Once the holes are marked, and aligned correctly, drill the
holes. Ensure the hole diametre is the same as the expanding screw pipe. Place the expanding screw pipe
into the holes, and then fix the two screws. Leave the tips of the screws exposed – about 10mm, and hang
up the heater.
