Hella Gutmann BPC-Tool, Руководство по эксплуатации

Страница: 25 / 44

BPC-Tool Working with the BPC-Tool
Performing a system test
NOTE
A blue current clamp (CP 700) is required for a complete
system test. Without a current clamp, the current intensity is
not measured during the starter and alternator tests. The
resistor test is not applicable at all.
NOTE
The BPC-Tool can display additional instruction texts on
request. To view additional instruction texts run through
steps 1–4 as described under
Configuring instructions
(Page 16) .
Proceed as follows to perform the system test:
1. Insert the electrical connector of the current clamp into the ST3
connection of the BPC-Tool with the arrow pointing down.
2. In the main menu, select System test and confirm with Select .
3. Select the vehicle type and confirm with Next .
4. Run through steps 3–10 as described in the section headed
Performing a battery test (Page 22) .
5. Follow the on-screen instructions.
The system test is carried out. The battery test result appears.
If the battery test was successful, the following appears:
• Charge and test again.
Allow the battery to charge completely and test it again.
• Good - recharge.
Allow the battery to charge and put back into operation.
• Battery OK.
Put battery back into operation.
• Cell defective, replace battery.
Replace battery and test it again, if necessary.
This message may also be displayed if the terminal contact with
the battery is insufficient, for example. In this case, disconnect the
battery and test it again by selecting
>Outside the vehicle< .
6. Continue the system test with the starter test with Next .
25