- 8 -
3/ ASSEMBLY - CABLES
STEP 8:
Before beginning to connect the cables, turn the tension dial
on the front of the Center Upright Tube to the right as far as
it can go. This is level 8 on the dial. This action will extend
the cable at the bottom of the Center Upright Tube to make it
easier to insert into the receiving cable.
See Figure #1
.
Take the cable that extends at the bottom of the Center
Upright Tube (
as shown in Figure #2
) and attach it to the
cable that is fixed to the main frame. (
See Figure #2
) The
inset image of
Figure #2
shows how to connect the two
cables. After connecting as shown in
Figure #2
, move the
lower cable bracket into place as shown in
Figure #3
and in
more detail in the insert
Figure #3a
.
Next, turn the Tension adjustment knob all the way to the
left; to level 1. This should release the tension on the black
plastic “sleeve” that is surrounding the cable as shown in
Figure #4
. If the adjustment has not completely loosened the
tension on the sleeve, pull up on the top cable to release this
plastic “sleeve”.
Remove the black plastic sleeve as shown in
Figure #4
by
pulling it off of the cable . The black “sleeve’ has a cut in one
side to allow removal. Once you have removed the black
“sleeve”, return the tension control all the way to the right to
level 8 and then back to the left to level 1. This will confirm
the connection is properly made and you will see both cables
move together.
STEP 9:
Now connect the two electrical wires as shown in
Figure #5
.
They are fit together only one way . If they are not
connecting easily, turn one of the connectors to find the
correct position to attach these two connectors. When
properly connected they should “snap” together.
The connectors should now look as they do in
Figure #7
.
1
2
3
4
5
6
7
3a
helix manuals_Helix H901 - May 2012 01/06/2012 10:39 Page 9
