- 5 -
3/ ASSEMBLY
STEP 1:
Put the product on the floor and remove the top box cover to reveal the Helix as show above. Where the box
corners are printed “OPEN”, cut or tear the box and separate these corners. Lay the sides flat to the floor
IMPORTANT:
Do not remove the
Helix from the box
bottom until further
instructed later in
this assembly
manual.
STEP 2:
Attach the End Caps (2) to the Left and Right Frame Legs. These caps are not specific to either side. They fit on
left or right. If the Helix is not stable on the floor, turn the adjuster on the front end cap to raise or lower the height.
STEP 3:
Each Left and Right Frame Legs are marked “L” and “R” with a sticker. While facing the Helix, place the left
left on the left side of the machine and the right leg on the right side of the machine.
Insert the Frame Leg assembly bolts into the lefts and secure using the “T” wrench as shown. Tighten these
bolts firmly.
IT IS VERY IMPORTANT TO MAKE SURE THAT THE LEFT AND RIGHT FRAME LEGS ARE ON
THE CORRECT SIDE OR THE HELIX WILL NOT ROLL PROPERLY
1
2
3
Remove all parts from the box leaving just the main body of the machine on the bottom of the box.
remove all patrs from their plastic bags and organise the floor beside the Helix
15
helix manuals_Helix H901 - May 2012 01/06/2012 10:38 Page 6
