STEP 12:
a. There should now be 3 wires. two coming from the handle bars and one that you held from the upright
when installing the handle bars. Hold all three wires together as shown in
Figure #1
above.
b. Take Top Cover (
part #9
) and position with the notch in the rear to allow wires to come out.
See arrow in
Figure #2.
c. Place plastic cover top onto the matching lower cover while making sure the wires are held through the
notch. (
See Figure #3)
d. Gently snap the top cover onto the lower cover until all edges are flush. Gentle but firm pressure is required
to snap the two covers together. (
See Figure #4)
for method to press parts together.
See Figure #5
for final fit with wires in hand
WATER BOTTLE HOLDER INSTALLATION
STEP 13:
Find the two bolt holes with bolts pre-installed in the Center Upright Post and remove those bolts (
Figure #1
)
Once bolts holes are empty (
Figure #2
) hold the water bottle holder up to the post as shown and install a bolt in
the lower hole in the water bottle holder bracket (
Figure #3
) and through to the lower bolt hole on the upright.
Do not tighten at this time.
Tilt the water bottle holder upright to align the top hole in the bracket with the top hole on the center upright
post. Install a 2nd bolt into that hole and then tighten with the allen key as shown in
Figure #4
.
- 10 -
3/ ASSEMBLY - COVER AND HANDLE BARS
1
2
3
4
5
1
2
3
4
helix manuals_Helix H901 - May 2012 01/06/2012 10:39 Page 11
