Helix Broadcaster 100 Touch Screen User Guide
CHAPTER 1: System Setup
5
5. Reboot the machine:
a. Close the
System Setup
screen.
b. Tap
Services
on the
Appliance Manager
menu.
c. Tap
Reboot Now
.
6. Navigate back to the
Network Setup
page and verify that the IP address has been set to the
correct value.
Helix Broadcaster Interfaces
Helix Broadcaster 100 provides three interfaces that allow you to perform various functions:
•
touch screen interface
This document describes the Helix Broadcaster 100 touch screen interface, which allows
you to perform basic encoding tasks. Using this interface, you can receive two network
inputs and two capture card inputs. For each input, you can encode up to three outputs.
•
browser interface
The browser interface (see page 7) gives you full access to Helix Broadcaster 100, providing
more encoding options than the touch screen. It allows you to configure the embedded
Helix Server as well as perform file-to-file encoding.
Note:
Once Helix Broadcaster is available on your network, you can use the
browser interface rather than the touch screen to carry out all system functions.
•
console menu
The console menu gives you access to Helix Broadcaster 100 configuration and network
functions. Once Helix Broadcaster is available on your network, you can use the console
menu through SSH as explained in Appendix A beginning on page 32.
Touch Screen Interface
When Helix Broadcaster starts up, it displays the
Appliance Manager
menu on its touch screen.
Appliance Manager Menu
System Functions and Services
The
Appliance Manager
icons give you access to the system functions.
System
Set basic system features such as the WAN IP address.
Services
Access system services such as rebooting the machine.
Stream Setup
Receive inputs as described in Chapter 2 and encode outputs as described in Chapter 3.