Helios MultiVent MV EC 125, Инструкция по установке и эксплуатации

Страница: 26 / 64

4
MultiVent ® MV EC
Installation and Operating Instructions
4
EN
If the temperature monitoring system trips frequently, this is a sign that a possible fault has occurred . The sys-
tem must not be operated and it must be investigated by a qualified electrician .
2 .10 Condensation
In case of periodical use, moist and warm media and through temperature variations (intermittent service), condensate
is built up in the duct and its draining off must be ensured. In case of condensation in ducting and casing of the fan,
appropriate measures must be taken (water bag, drainage) during installation. Under no circumstances must the motor
be exposed to water.
3 .0 Overview
3 .1 Dimensions (
Dimensions in mm)
ATTENTION
m
Control of several EC-fans with a potentiometer
In order to control several EC fans via the setpoint input “0-10V”, the 10 V DC voltage source must provide the
sum of all setpoint input load currents.
m
Parallel connection of +10 V DC supply of several EC fans is not permitted!
Depending on the type several EC-fans can be controlled with the 10 V DC power supply from a fan with a poten-
tiometer (PU/A). For this see the technical data of the control inputs and the wiring diagram SS-1035.
If the power of the EC-supply is not sufficient a customer-supplied sufficient external 10 V DC can be used (gal-
vanically separated from the mains). Alternatively the Helios module “EUR EC“ can be used for various control
duties. The control cable must have the same insulation level as the mains cable.
WARNING
m
CHAPTER 3
TECHNICAL DATA
ö
ü
ò
ä
ò
Casing made of impact and
corrosion-resistant polymer
ù
High-performance impeller and
ä
Guide vane made of polymer optimised
for high pressure and volume output
ë
Terminal box on outside of casing
in IP44
ö
Integrated mounting bracket for
mounting to wall and ceiling
ü
Clamp with screw connection
Fig .5
ë
Fig: Section view
ù
Fig .6 MV EC125 Fig .7 MV EC 160
Fig .8 MV EC 200 Fig .9 MV EC 250 Fig .10 MV EC 315