Helion Invictus 10MT, Инструкция пользователя и развернутые схемы

Страница: 17 / 40

TROUBLESHOOTING GUIDE
17
1/10th SCALE 4x4
BRUSHLESS POWERED
MONSTER TRUCK
Problem / Symptom Possible Cause Possible Solution
Vehicle will not turn on
Battery voltage too low Charge battery
Battery not connected Re/connect battery
Damaged battery Replace battery
Transmitter will not turn
on Battery voltage too low Charge or change batteries
Battery/ies installed improperly Correct installation
Short radio range (Ve-
hicle stops responding
to transmitter at short
distances) Damaged or improperly installed re-
ceiver and antenna
Check receiver antenna for damage. Ensure antenna is
properly installed in tube and mount, extending perpendicular
from the ground. Ensure all connections are secure
Receiver is malfunctioning Replace receiver
Battery voltage too low Replace or recharge batteries in transmitter and vehicle
Steering not responding
as expected
Trim not set properly Adjust steering trim
Screws too tight on steering parts Adjust screws to allow for free motion
Fasteners have become loose
Check and tighten all fasteners to as new condition, be care-
ful to not over tighten
Vehicle not responding as
expected to transmitter
Trims not set properly Adjust throttle and/or steering trim
Radio system lost bind Re-bind radio system
Bad electrical connections
Check motor and battery plugs to ensure they are fully con-
nected
Wheels twitch while
vehicle is idle (controls at
neutral)
Transmitter too close to receiver (<1m) Increase distance between the units
Receiver wire damaged Inspect antenna for damage and replace if necessary
Receiver antenna not installed in vertical
position
Install in mount with care to not damage antenna wire
Steering will not trim
straight, always has right
or left bias Binding in steering system
Inspect and correct any binding components or loosen
screws if over tight
Front wheels too tight
Check and adjust wheel nuts to ensure the wheels are not
too tight
Vehicle top speed and
acceleration is slow
Battery voltage too low Charge battery
Drivetrain has too much friction Check for debris/excessive wear on gears, inspect bearings
Gear mesh too tight Loosen gear mesh
Pinion gear is loose Check and tighten set screw on motor pinion
Differential broken
Check differential and ensure the outdrives are secured and
gears intact. You should not be able to pull them out
Drive pin missing
Check for missing wheel pins (behind wheel hexes), or dog-
bone pins
ESC not set to transmitter Follow ESC instructions to set to transmitter
Wheels not spinning
freely Wheels too tight Check and adjust wheel nuts
Differentials stripped Check differentials and replace/repair if necessary
Battery charge stops
lasting as long as it used
to
The battery has become old Replace battery
Battery not charged completely due to
insuffi cient charge time Charge for longer period of time or try a peak detection char-
ger. We recommend the Radient Primal (RDNA0001)
Gear mesh too tight Check and reset gear mesh setting
Charger, battery, wires, or plug has
malfunctioned Check all connections and wires for damage or excessive
wear and replace if necessary
Shocks and/or arms
covered in oil
Shock O-ring seals are worn Replace O-rings and refi ll shock with oil
Top shock cap too loose or over tight-
ened
Check tightness (fi nger tight), refi ll shock oil
Bottom shock cap dislodged Check installation, refi ll shock oil
Spur gears stripping
Gear mesh too loose Tighten gear mesh for proper backlash
Fasteners loose or missing
Check for loose fasteners on spur gear mount and ensure all
E-clips are in place