H. Vollmer GmbH
ǀ
Allmendring 29
ǀ
75203 Königsbach-Stein
ǀ
www.HEITRONIC.de 3 / 8 12/21
GB Installation and Operating Instructions
Solar LED Writing Board SLATE
Art. No. 501243
These operating instructions belong exclusively to the product. It contains important
information on the commissioning and handling of the luminaire. Therefore, please pay
attention to these operating instructions, even if you pass this product on to third parties.
Please keep these instructions in a safe place for future reference.
1. Introduction
Dear customer, thank you for purchasing our product. You have purchased a product from Vollmer,
which has been built according to the current state of the art. The luminaire meets the requirements of
the applicable European and national directives. In order to maintain the condition of the product and to
ensure safe operation, you as the user must observe these operating instructions!
2. Safety instructions
•
In case of damage caused by non-observance of these operating instructions, the warranty claim
expires!
•
We do not assume any liability for consequential damages!
•
Do not bring the lamp into contact with extreme heat or open flame.
•
We accept no liability for damage to property or personal injury caused by improper handling or
non-observance of the safety instructions.
•
In such cases, all warranty claims are void.
•
The entire product must not be modified or converted. Modifications to the product will void the
warranty.
•
The type plate must not be removed
.
3. Intended use
The solar luminaire is designed for outdoor use. The built-in rechargeable battery is charged by the
solar cell in the base of the luminaire. The product switches on automatically at dusk and off again at
dawn. Powerful light-emitting diodes (LEDs) are used as the light source. These LEDs guarantee high
luminous intensity with low power consumption.
Please note, however, that if there is little sunlight on the solar module and in the winter months, the
light duration / light output may be impaired.
Note: In longer periods without sunlight, the battery is insufficiently charged so that no constant
operational readiness can be guaranteed. However, this does not mean that the solar luminaire is
defective. Wait for the next sunny days and the luminaire will be usable again according to its function.
4. Start-up and runtime
•
Take the solar luminaire carefully out of the packaging.
•
Remove the protective film
•
Place the solar luminaire in the desired location, observing the safety and warning instructions, and
operate the switch. (underside of the housing).
•
For initial charging, find a suitable location with direct sunlight.
•
Make sure that the solar unit of the solar LED luminaire is directly illuminated by the sun. Shadows
on the solar unit will affect the charging function of the battery.
•
The solar LED luminaire is charged by the solar panel.
•
Due to the day/night sensor, it will turn on automatically at dusk.
•
Make sure the day/night sensor of the luminaire is not affected by any other light source.
Otherwise, the luminaire will not turn on at dusk.
•
There is no possibility to change the lamp
•
The board can be written on with all commercially available whiteboard markers.
Note: The light duration / light intensity is strongly dependent on the duration and intensity of sunlight
during the day. In the winter time, a shorter luminous period is generally to be expected. If the lamp
does not light up on the first evening, please wait for one or two sunny days.
