CARLTON NZAust v1.3 Nov 2019
Page
2
of
3
INSTALLATION OF CARLTON LADDER TOWEL WARMER
SPECIFICATIONS
Mounting Centre
(Approx Width)
Rating at 230-240
Volts AC
Voltage
IP
Rating
Model WCA1000 (6 Rungs)
572mm
100 Watts
230-240VAC
IP45
This Package Contains:
1 Ladder Towel Warmer
3 x Hex Cap screws for mounting legs to frame (not flexed Leg)
1 x Mounting leg with grub screw (on flex)
4 x Screws to fix Wall Mounts
3 x Mounting legs
1 x Small Allen key for grub screws
4 x Wall Mounts with grub screws
1 x large Allen key for Hex Cap screws
(one with cut out for concealed wiring)
1 x Handle for Allen keys
CAUTION:
Prior to installation please ensure the product is to your satisfaction. Once installed Heirloom cannot be responsible for defects
in the product finish. This product is not intended for use by young children or infirmed persons without supervision. Young children should
be supervised to ensure they do not play with the product. To minimize a hazard for young children, this appliance should be installed so
that the bottom rail is 600mm above the floor. If the supply cord is damaged it must be replaced by the manufacturer, its service agent, or
similarly qualified persons in order to avoid a hazard.
Installation:
NOTE: This towel warmer is made in right hand wiring only
This towel warmer must be installed by a registered electrician and in accordance with local and national electrical codes. We recommend
that the towel warmer be installed vertically on a flat and uniform wall, and where possible into studs or other suitable anchor material. If
fixing to hollow cavity walls, Toggle Anchors (not those supplied) or similar devices must be used.
Position the towel warmer so that the plug and mains power receptacle are easily accessible, with the cable entry to the towel warmer
NEAREST THE FLOOR. Avoid the supply cable coming into contact with the heated parts of the towel warmer.
DO NOT PLUG THE UNIT INTO THE POWER SUPPLY OR SWITCH THE TOWEL WARMER ON BEFORE INSTALLATION IS
COMPLETE.
The following instructions are for mounting the towel warmer with exposed flex
1
Attach the 3 mounting legs to the towel warmer with the Hex Cap Screws (Making sure the grub screw in the leg will face the
floor)
2
Mount
the “Flex Leg” on to the
Towel warmer with its grub screw (ensuring that the leg is facing in the correct direction).
3
Place a Wall Mount over the end of the two top legs but do not secure them in place
4
Hold the towel warmer in position and mark around one of the Wall Mounts on one of the top legs. Remove the towel warmer .
5
Screw the Wall Mount into the position marked
6
With a Wall Mount placed over the end of the other top leg place the top leg into the Wall Mount. Make sure that the towel
warmer is level, and mark the location of the remaining Wall Mount on the other top leg. Remove the towel warmer.
7
Screw the Wall Mount into the position marked
8
Place the towel warmer onto the two top Wall Mounts and mark the location of the two bottom legs.
9
Remove the towel warmer and fix the remaining Wall Mounts to the wall
10
Place the towel warmer in position and secure it to the Wall Mounts with the grub screws.
