Artos Wall NZAust v1.3
INSTALLATION OF ARTOS WALL SERIES TOWEL WARMER
SPECIFICATIONS
Voltage
Model WA600W
Artos Wall
107 Watts
240 VAC
Model WA490W
Artos Wall
77 Watts
240 VAC
This Package Contains:
1 Towel Warmer and Leg Kit
Mounting Barrels & Screws Mounting Template (Paper)
CAUTION
Prior to installation please ensure the product is to your satisfaction. Once installed Heirloom cannot be responsible for defects in
the product finish
. This product is not intended for use by young children or infirmed persons without supervision. Young
children should be supervised to ensure they do not play with the product
. If the supply cord is damaged it must be replaced
by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
Installation:
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical supply, plug & switch location,
and product location will comply with your local regulations. We recommend that the towel warmer be installed on a flat and
uniform wall, and into studs or other suitable anchor material. While not recommended, if fixing to hollow cavity walls, Toggle
Anchors or similar devices must be used.
Position the towel warmer so that the plug and mains power receptacle are easily accessible, with the cable entry to the towel
warmer NEAREST THE FLOOR. Avoid the supply cable coming into contact with the heated parts of the towel warmer
.
DO NOT CONNECT THE UNIT TO THE POWER SUPPLY BEFORE INSTALLATION IS COMPLETE.
WA600W
WA490W
1.
If the towel warmer is to be installed with concealed wiring the concealed wiring instructions below should be followed for
the first leg mount. Thereafter revert to these instructions at point 2 below, and use the template to position the other
three legs once the template has been aligned with the concealed wiring fixing point.
2.
Attach the legs to the warmer
3.
IMPORTANT
: Leg Location: Check that the distance from left to right side of the template matches the towel warmer.
Place the towel warmer onto the template so that the top legs of the towel warmer align with the top fixing points on the
template. Adjust the markings on the template to match the towel warmer if necessary (if the template is more that 3mm
out). Repeat for the width of the bottom legs.
Do not adjust the template for the vertical spacing between legs from top to bottom. If however the vertical distance is
more than 8mm different from the template contact Heirloom for installation advice
4.
Place the enclosed paper template on the wall with removable tape holding all four sides in place. Make sure the marked
fixing points are level both horizontally and vertically. Mark the centres of each fixing point (If mounting with concealed
wiring then first align the template with the leg that has the concealed wiring point)
5.
Drill the holes through the wall cladding into a stud, fix the mounting barrels and place the warmer legs onto the
mounting barrels. This may require gentle force to adjust the spacing of the legs to match the mounting barrels
6.
Once the towel warmer is in position, secure the warmer in place with the grub screws
