Artos Wall NZAust v1.3
Concealed Wiring Option Instructions
:
.
1.
Ensure that the flush box that the towel warmer will be wired to can be reached by the flex from the
mounting position of the towel warmer. Allow for loss of flex length due to connections.
2.
Drill a 12.5mm hole into the face of the stud where the towel warmer foot with the flex is to be
positioned. Drill the hole approximately 25mm deep. (On masonry walls drill a 14mm hole.)
3.
Identify the side of the stud facing the flush box that the towel warmer will be wired to. On that side of
the stud, drill a 25mm deep hole at right angles to this first hole so that the hole will break into the base
of the first hole. Refer to Fig1.
9.
Place a pull through line from the flush box and out the 12.5mm hole so that the line can be picked up later
once the wall cladding is in place
10.
When the wall cladding is installed a hole will be required to provide access to the above 12.5 mm hole in
the stud. Locate the pull through and leave hanging out of the hole that has been created in the wall cladding.
(
NOTE
: care must be taken to ensure that the hole created in the wall cladding is a lesser diameter than that
of the towel warmer leg to ensure that the hole in the cladding will be concealed by the towel warmer leg
when it is fixed into position)
11.
When installing the towel warmer, thread the pull through line, through the concealed mounting adaptor and
screw the mounting adaptor into position. The pull through line should now exit through the concealed
wiring adaptor. (On masonry walls epoxy resin the adaptor into position). (refer Fig 2)
