ROTARY HAMMER
Chiseling operation
First set the mode selector switch
4
and the mode selector switch 5 to the position shown in the
figure 4
.
Hold the tool firmly with both hands. Turn the tool on and apply slight pressure on the tool so
that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not
increase the efficiency.
Drilling operation
First set the mode selector switch
4
and the mode selector switch 5 to the position shown in the
figure 5
.
Use the drill chuck assembly, you can drill up to 13 mm (1/2”) diameter in metal and up to 40
mm (1-
9/16”) diameter in wood
.
WARNING:
•
Never use “Hammer drilling” when the drill chuck assembly is installed on the
tool. The
drill chuck assembly may be damaged.
•
Pressing excessively on the tool will not speed up the drilling. In fact, this excessive
pressure will only serve to damage the tip of your bit, decrease the tool performance and
shorten the service life of the tool.
•
There is a tremendous twisting force exerted on the tool/ bit at the
•
time of hole breakthrough. Hold the tool firmly and exert care when the bit begins to break
through the workpiece.
•
Always secure small workpieces in a vise or similar hold down device.
MAINTENANCE
WARNING:
•
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
•
For safe and proper working, always keep the tool and ventilation slots clean.
•
The tool may be cleaned most effectively with compressed dry air.
Always wear safety
goggles when cleaning tools with compressed air.
•
Certain cleaning agents and solvents damage plastic parts.
Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents
that contain ammonia.
Drill chuck assembly
Fig. 10