Heinner HOH-D11, Инструкция по эксплуатации

Страница: 18 / 48

www.heinner.com 2500W, 50/60Hz, 220-240V
17
V. ASSEMBLY
1. Unscrew nut and washer from casters.
2. Turn the heater upside down for ease of assembling
3. To attach the castor groupware to the radiator body ,put the front castor groupware
on the front cover
，
and the screws with the front cover must be through the orifice on
the front castor groupware;Put the back castor groupware on the last two fins and place
wing nut onto U bolt and tighten it firmly.
4. After having attached all caster assemblies, DO NOT forget to return the heater to its
upright position for operation.
DO NOT operate the heater without the caster assemblies attached to the bottom of
the unit. Otherwise it may result in a fire hazard.
WARNING: Operating the radiator upside down may cause fire. This heater is equipped
with a tip over switch, if for any reason, the heater is operated while it is tipped over,
power will be cut off automatically. No measures should be required to repair it. Once
placed in the correct upright position, it will begin to work normally.
If you are in doubt, please consult a qualified electrician before use.
VI. USING INSTRUCTIONS
DO NOT operate the heater unless it is place in an upright position.
Select an indoor location for the heater away from electrical cords, drapes and other
furnishings. DO NOT place heater directly beneath an electrical outlet or against paper
board or low density fiberboard.
Insert the plug of the heater into a suitable socket with thermostat knob at MIN position
and power selecting knob at OFF position.
Turn on the heating elements by turning the power selection knob. When the heating
element are on, the power indicator light will illuminate.
Turn the power selecting knob to position LOW, the power level is 1000W.
Turn the power selecting knob to position MED, the power level is 1500W.
Turn the power selecting knob to position HIGH, the power level is 2500W.
The first time the heater is used there may be an odor that will disappear after the first 30
minutes of operation. The odor is due to a lubricant used during the manufacturing the
heater.