Heinner HIS-D3006V, Руководство пользователя

Страница: 22 / 49

www.heinner.com 3000W, 50/60Hz, 220-240V
Steam ironing
1. Put the unit base on a stable and level surface.
2. Grasp the water tank’s handle to remove the water tank, then fill it with water through
the filling aperture. You had better use purified water with less calcium particles. After it,
replace the water tank properly. The max capacity of water tank is 1.7L, the water level
shall not be exceeded the MAX mark.
2.1 Put the iron on the thermal insulation stand of unit base.
3. Connect the appliance with power source, press down the power button, and the
defaulted low steam rate indicator will blink. And there are three modes including low,
medium and high steam rate available, you can select the desired steam rate for each
garment according to your requirement. Make sure that there is enough water in the
tank.
4. Turn temperature dial to your desired setting, which is depended on the fabric of
garment. The iron starts heating, and the temperature indicator will illuminate solidly
during heating. Refer to “IRONING TIPS” and “ADDITIONAL TABLE” as below when select
temperature.
5. After a few minutes, the temperature indicator will extinguish, it indicates the soleplate
temperature has achieved the selected temperature. When the indicator of selected
steam rate changes from flashing to illuminating, it indicates that the iron is ready for
ironing garment with steam.
6. Press the steam trigger with a little force, the steam will be sprayed from the soleplate
continuously, and then you can iron the garment with steam.
7. Quickly press the steam trigger twice to produce shot of steam if you need to remove
hard crease. The “Shot of steam” function can be only activated under medium steam
rate and high steam rate.
Note: There may be dripping water during spraying steam when the temperature of the
soleplate is at and lower than the second setting. This is normal.
Caution:
1) Do not touch hot soleplate at any time before cooling down!
2) Never direct the steam at people!
3) Do not activate the steam trigger when the iron is placed on the unit base to avoid
being scalded by steam.
8. After ironing, press down the power button for more than 2 seconds, the appliance will
be turned off and all the indicators will extinguish. Remove the plug from the wall socket.
But the soleplate is still hot, never touch it with hand, place it on the thermal insulation
stand until it cools down completely.