Heinner HIS-D3006V, Руководство пользователя

Страница: 19 / 49

www.heinner.com 3000W, 50/60Hz, 220-240V
CONTROL PANEL
Filling aperture
Fill the water tank with water through the filling aperture. Make sure that the water shall
not exceed the MAX mark of water tank.
Power button
Plug in the appliance and press down the power button, the power indicator will
illuminate, the low steam rate is regarded as defaulted one and its indicator will blink.
Hold and press the power button for more than 2 seconds, the appliance will be cut off.
Steam rate control button
The steam rate can be selected low, medium or high by the steam rate control button. Any
one to be selected, its indicator will blink, and it will illuminate solidly after finish
preheating, which means that the steam is ready for use. The indicator of selected steam
rate will blink when the steam rate is switched from low setting to high setting, while it
will illuminate solidly when the steam rate is switched from high setting to low setting.
Temperature dial
Turn the dial to set ironing temperature based on the garment needs to be ironed.
Temperature indicator
The appliance will heat up when it has not reached the selected temperature. The
temperature indicator will illuminate when the appliance is heating up. Once the
appliance has reached the selected temperature, the temperature indicator will
extinguish. The temperature indicator will be cycled on and off as the iron maintains the
selected temperature during ironing.
Steam trigger
After pressing down the power button and choosing the desired steam rate, it indicates
the steam can be used for ironing when the steam rate indicator changes from blinking to
illuminating solidly. At that time, press the steam trigger with a little force, the steam will
be sprayed from the soleplate continuously. When loosen the steam trigger, the appliance
can only be used for dry ironing without steam.
Shot of steam
Quickly press the steam trigger twice to produce shot of steam. An interval of at least 15
seconds must be maintained between two continuous cycles. The “Shot of steam”
function can be only activated under medium and high steam rates.