Heinner HIS-D2403BL, Руководство пользователя

Страница: 19 / 45

www.heinner.com 2400W, 50-60Hz, 220-240V
V. USING INSTRUCTIONS
BEFORE FIRST USE
1. Remove any sticker, protective foil or storage cover from the soleplate.
2. Heat up the iron to maximum temperature and iron over a piece of damp cloth for
several minutes for the purpose of removing any residue on the soleplate according to
the section of “Steam ironing”.
3. Before first use, detach the de-calc box and then immerse it into the water for more
than one minute.
NOTE: It is normal that strange odor comes out from the unit for the first use. This will
cease after a short while.
NOTE: Some particles may come out of the soleplate when you use the iron for the first
time. This is normal; the particles are harmless and stop coming out of the iron after a
short while.
NOTE: When you switch on the appliance, the steam generator may produce a pumping
sound. This is normal; the sound tells you that water is pumped into the steam generator.
NOTE: During the heating process of the soleplate, there will be little steam coming out
from the soleplate automatically and this phenomenon will continue for about 3 seconds,
This is normal.
USING YOUR STEAM STATION IRON
The appliance has two iron portions. You can use dry ironing or steam ironing. The details
refer to the following:
Dry ironing
1. Put the iron on the thermal insulating cushion.
2. Connect the plug to wall outlet, together with one beep can be heard. And then press
down the Power button, the power indicator starts to illuminate.
3. Turn temperature dial to your desired setting, which is depended on the fabric of
garment, and the temperature indicator will illuminate. Refer to IRONING TIPS latter. The
iron starts heating.
4. When the temperature indicator turns off, the selected temperature is reached. You
now can start ironing.
WARNING: Never touch hot soleplate at any time before cooling down!
Steam ironing
1.
Grasp and press the water tank’s handle to take out of the water tank, then open the
filling aperture cap and fill water into the water tank. You had better use purified
water with less calcium particles. After it, close the filling aperture cap. The max
capacity of water tank is 1.2L, the water level shall not be exceeded the MAX mark.
2. Replace the detachable water tank properly.
3. Put the iron on the thermal insulating cushion.