www.heinner.com 850W, 50Hz, 220-240V
3
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance
before making coffee, including the funnel and cup, so that the coffee flavour will not be
influenced by the cold parts.
1.
Remove the detachable tank and open the tank cover to fill it with desired water, the
water level should not exceed the “MAX” mark in the tank. Then place the tank into the
appliance properly.
2.
Select the two –cup mesh, Set steel mesh into metal funnel, make sure the tube on the
funnel aligns with groove in the appliance, then insert the funnel into the appliance from
the “Insert” position, and you can fix them into coffee maker firmly through turn it
anticlockwise until it is at the “Lock” position.
3.
Place an espresso cup on removable cup shelf.
4.
Then connect the appliance into power supply. Make sure the steam knob is at the OFF
position.
5.
Press the power button “
” one time, the red indicator is illuminated, make the
coffee/steam selector on the “
” position. Press the pump control button on the “
”
position, when there is water flowing out, close the pump immediately. The purpose of
the step is to pump the water of the tank into the housing.
6.
When the lamp in pump control switch is illuminated, you should press the pump control
switch on the “
” position again, there will be hot water flowing out. When the lamp in
it is extinguished, close the pump. The pre-heating is finished.