Heinner HCM-1200D, Инструкция по эксплуатации

Страница: 15 / 45

www.heinner.com 1000W, 50Hz, 230V
14
4. Insert the carafe horizontally on the keeping warm plate.
5. Plug the power cord into the outlet, the LCD will display “12:00” (see “Control
panel”).
6. Press the “ON/OFF” button, the red lamp of RUN will be illuminated. The
appliance will begin working.
Note : You can take out the carafe, pour and serve at any time. The appliance will
stop dripping automatically. But the time cannot exceed 30 seconds.
7.
Do not open the tank cover when the coffee maker is operating. The flow back
of hot water will damage the appliance.
8. You can take out carafe, pour and serve when the brewing is finished (about
one minute later after the coffee stops dripping out).
Note : The coffee you get will be less than the water you have inputted in, as some
water is absorbed by the coffee ground. As safety is concerned, you shall better
cover the lid of carafe when pouring, this is good to keep the coffee warm, too.
9.
Always turn off the coffee maker and unplug the power cord from the electrical
outlet when the coffee maker is not in use.
Note : Pay attention when pouring the coffee out, otherwise you may get hurt as
the temperature of the fresh coffee is high.

Automatic start function:
If you do not want the coffee maker to start operating immediately, for example now it
is 8:10 am, and you want that the coffee maker to automatically start at 1:00 pm, first
you have to follow the below steps, then you can set the automatic start function as
follows:
1) Press “PROG” button, the “LCD” will display “CLOCK”.
Set the current time by pressing the “HOUR” and “MIN” buttons (see Fig.1).
Note: The time cycle is 24 hours. Select the desired time by pressing the
“HOUR” and “MIN” buttons continuously.
2) Press “PROG” button again, and the “LCD” will display “TIMER”, then set
the automatic start time by pressing the “HOUR” and “MIN” buttons
(fig.2).