Heiniger TPW Aussie Xpress, Руководство оператора

Страница: 9 / 25

MA005 TPW Woolpress Operator Manual 2019-06-06
Rev:05
9
10. Start the motor and ease the control valve handle up to raise the platen until the
unpinning post pins are level with the tips of the pawls when the pawls are held with
the tip at its lowest possible point
(see illus at 12.10) . Stop the motor.
Warning: Do not attempt to hold any part of the press components (accept for the control
valve handle) when raising the cylinder or platen.
11. Ensure that the gap between the tip of the pawl and the unpinning post pin is even on
both sides. (see illus at 12.10)
12. Tighten the mounting bolts & nuts securely. Remove the support bars from the press.
13. Fit the load cell foot and remove the transport feet.
14. Adjust the load cell foot so the press is level. Tighten the load cell foot lock nut against
the load cell.
15. Secure the jockey wheel in its catch and check to ensure that the jockey wheel brake
foot is clear of the floor.
16. Fit the indicator onto its bracket and plug the load cell lead into the indicator.
17. With the press closed, plug the power supply in, then switch on using the ON/ZERO
key. The display should indicate zero,
▲
. If not press ON/ZERO. Applying weight to
the press structure should register a reading.
18. Before operating the wool press, lubricate all moving parts. When the bellcranks and
baling pins are lubricated fit the pinning guards. (see illus)
19. Start the woolpress and cycle it a few times to expel any air, which may be trapped in
the hydraulic system.
9
Jockey Wheel
To use the Jockey Wheel pull it free of the catch and lower it towards the floor, this
transfers the weight of the woolpress from the loadcell foot to the Jockey Wheel.
The woolpress is now ready to move.
To use the brake foot lift the Jockey Wheel handle up about half way, retain a firm grip on
the handle, when the brake foot contacts the ground it will stop the woolpress.
When the woolpress has come to a complete stop lift the Jockey Wheel up and push the
plastic knob firmly into the catch to secure it.
Note: When pressing wool ensure that the Jockey Wheel is secured in the catch and the
loadcell foot is fitted to the correct height so the brake foot on the Jockey Wheel is clear of
the floor.
When moving the woolpress the loadcell foot must be clear of the floor.
When using the Jockey Wheel do not release it until it has been secured in the catch. If
released, unrestrained upward movement can cause damage to the woolpress.
Do not allow any part of your body to come between the Jockey Wheel and the woolpress.
When moving the woolpress it is important that it has come to a complete stop before
lowering the weight of the woolpress onto the loadcell foot.
The woolpress should not be used or moved on uneven, unstable or sloping surfaces.
10 Jockey wheel illustration