3
PRePARAtIOn
Assembly
(refer Fig. 1)
1. Make sure all parts are present. If any part is
missing or damaged, do not attempt to assemble,
install or operate the product. Contact
Hein-Werner
Customer Service (816) 891-6390
.
2. Insert Extension Tube into the Collar and attach
securing fastener into hole in Collar to prevent
inadvertent removal.
Before Use
1. Verify that the product and the application are
compatible, if in doubt call
Hein-Werner
Customer
Service (816) 891-6390
.
2.
Inspect stands before each use. Do not use if there are
bent, broken or cracked components noted (including
labels). Ensure that all parts move freely.
3. Read the this operator's manual completely and
familiarize yourself thoroughly with the product and
the hazards associated with its improper use
before
using this product.
4. Always refer to the vehicle owner's or service manual
for location of proper lift and support points.
OPeRAtIOn
Use only
on areas of the vehicle as specified by
the vehicle manufacturer.
Use ONLY
on vehicles
whose support points are
compatible
with the
saddle of the jack stand. Incompatibility may
result in structural damage to the vehicle and/or
jack stand. Structural damage to either may result
in sudden and unexpected loss of load height!
Only attachments and/or adapters supplied
by the manufacturer shall be used.
1. Change Saddle height by adjusting the Extension
Tube, then insert the Support Pin through
both
Adjustment Holes in Extension Tube.
2. Check that Support Pin is securely seated across
cutouts in top of Collar before loading. Ensure that
Support Pin is inserted completely so that bar stop
engages the collar.
3. Carefully position jack stands so that load will be
centered
on stand’s saddle.
4.
Slowly
lower the vehicle onto stands.
5. Check to ensure vehicle is secured before working
on, around or under. Use wheel chocks on all unlifted
wheels in both directions to prevent inadvertent
movement.
to lower load
Be sure that all tools and personnel are clear
before lowering load.
1. With suitable jack, raise vehicle clear of stands.
2. Carefully release Support Pin and adjust Extension
Tube to lowest position.
3. Carefully remove stands, then lower vehicle with lift
device.
MAIntenAnCe
To help prevent rust, wipe clean after each use. Do
not apply oil or lubricant to ANY portion of this product.
Always keep Support Pin with base section and replace
Lanyard if necessary.
If rust appears, sand affected area and cover with
suitable utility paint. Please note that there is no
replacement part applicable to this device.
Storage
Store stands in upright position and in a clean, dry
area.
RePLACeMent PARtS
For replacement partsd, product labels and owners
manual, call or write: Hein-Werner Customer Support,
10939 N. Pomona Ave. Kansas City, MO 64153, U.S.A.
Tel: (816) 891-6390 Fax: (816) 891-6599 E-Mail:
Some components of these jack stands are not available
for replacement. Jack stands
must
be replaced as a
matched set and must never be used singly or with
another make or model stand.
•
Rated capacity is PeR PAIR! DO nOt
exceed
rated capacity.
• Use as a matched pair to support one end
of a
vehicle only. Use only
One (1) PAIR
per vehicle.
• Use only on hard, level surface.
• Center load on saddle.
•
Jack stands are not to be used to simultaneously
support both ends or one side of a vehicle.
• No alterations shall be made to this device.
!
WARNING
!
!
!
!
WARNING
To avoid
crushing and related injuries
:
neveR
work on, under or around a
load supported only by a hydraulic
jack.
ALWAYS
use adequately rated
jack stands.
