10
328 014525201
Specifications subject to change without notice.
The power cord reference power cord standard recommending table.
Fig. 14
-
Power cord
Install the panel
1. Set the panel to the indoor unit body by matching the position of
the panel’s swing flap motor to the panel’s piping position to the
indoor unit’s piping position (see Fig. 15).
2. Install the panel
(1.) Install the panel on the indoor unit temporarily. When
installing, hang the latch on the hook that is located on
the opposite side of the swing flap on the panel of the
indoor unit (two positions).
(2.) Hang the remaining 2 latches to the hooks on the sides
of the indoor unit. (Be careful not to let the swing motor
lead wire get caught in the sealing material).
(3.) Screw the 4 hexagon head screws under the latches in
about 3/5 in (15 mm). The panel should rise.
(4.) Adjust the panel by turning it toward the direction
pointed by the arrow (see Fig. 15) so the adjust board
connects well to the ceiling.
(5.) Tighten the screws until the thickness of the sealing
material between the panel and the indoor unit is
reduced to 5
−
8mm.
1/5 in to 1/3 in (5 mm to 8 mm)
Fig. 15
-
Panel Installation
NOTE
:
(1.) Improper screwing of the screws may cause issues as
shown in Fig. 16.
Air leak
Air leak from ceiling
Water condensatation, water drop
Fig. 16
-
Improper Screwing
(2.) If a gap still exists between the ceiling and decoration
panel after tightening the screws, readjust the height of
the indoor unit (see Fig. 17).
If the raising lever and drain hose are
not affect, can adjust the height of
indoor unit by the hole on the corner
of panel.
Gaps are not allowed
Fig. 17
-
Improper Screwing
IMPORTANT:
After securing, ensure there is no gap between the
ceiling and the panel.
(3.) Wiring of the decoration panel (Fig.18). Connect the
joints for the swing flap motor lead wire (at 2 places)
onto the panel.
At body
At pane
At body
At pane
Fig. 18
-
Connect joints
