HEIDENHAIN TNC 426 CB, Техническое руководство

Страница: 735 / 1135

December 2001 Tool Changer 6 – 405
Module 9092 Searching for an entry in the tables selected for execution
(.T/.D/.TCH)
Prerequisite for table: M status must be set.
The entry or value sought is given as a natural number, shifted by the number
of decimal places that can be entered.
As return code the function replies with the number of the line in which the
value was found.
It is possible, for example, to look for the vacant pocket (corresponds to T0) in
the pocket table.
If you wish to look for more occurrences of the same value, you must enter
the line number of the last occurrence plus one as the starting line.
Call:
PS
B/W/D/K <File type>
0: .T file (tool table)
1: .D file (datum table)
2: .TCH file (pocket table)
PS B/W/D/K <Element value>
PS B/W/D/K <Element number>
.T file:
0: Tool length (L)
1: Tool radius (R)
2: Reserved
3: Replacement tool (RT); (–1= not defined)
4: Reserved
5: TIME 1
6: TIME 2
7: CURRENT TIME
8: Tool radius 2 (R2)
9: Oversize for tool length (DL)
10: Oversize for tool radius (DR)
11: Oversize for tool radius 2 (DR2)
12: Tool locked (TL); (0: No, 1: Yes)
13: Number of the tool teeth (CUT)
14: Wear tolerance for tool length (LTOL)
15: Wear tolerance for tool radius (RTOL)
16: Cutting direction of the tool (DIRECT); (0:+; 1: –)
17: PLC status (PLC)
18: Tool offset for tool length (TT:LOFFS)
19: Tool offset for radius (TT:ROFFS); ($7FFF FFFF = R)
20: Breakage tolerance for tool length (LBREAK)
21: Breakage tolerance for tool radius (RBREAK)
22: Tooth length (LCUTS)
23: Plunge angle (ANGLE)
24: Tool number
25: Tool index
26: PLC value (PLC-VAL)
27: Probe center offset in reference axis (CAL-OF1)
28: Probe center offset in minor axis (CAL-OF1)
29: Spindle angle during calibration (CAL-ANG)