Hedson IRT-UVA-1 PrepCure 4, Инструкция по эксплуатации

Страница: 3 / 12

714850 rev 1
3
When using an electrical equipment, basic precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING IRT-UVA 1/2 Prep-
Cure 4 Digital
WARNING
UV RADIATION CAN CAUSE PERSONAL INJURY AND
PROPERTY DAMAGE!
WARNING
UV emitted from this product. Skin or eye
injury could result. Avoid exposure of
eyes and skin to unshielded lamp.
To reduce risk of injury, or property damage from UV radiation,
read, understand, and follow the following safety instructions.
In addition, make certain that anyone else that uses this heating
equipment follows these safety instructions as well.
• The Equipment emits more than 0.1 μW/cm2 and
shall only be used in locations where access to the
equipment and the emissions is restricted to qualified
personnel.
• Wear protective clothing. Hands, face and other
parts of the body shall not be exposed to heat and
radiation. Do not stay in front of the lamp cassettes
during curing without safety equipment.
• Always wear eye protection. Failure to this may result
in longterm injury to the eyes.
• If a person works around UV radiation while on
medications, the medication should be checked to
see if it would make the person more photosensitive.
• Do not look directly at the light source.
• Do not use if protective glass is broken or missing.
This glass filters the light from unwanted radiation.
WARNING
To reduce the risk of fire, electric shock, or injury:
• Do not leave equipment when plugged in. Unplug from
outlet when not in use and before servicing.
• Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
• Use only as described in this manual. Use only
manufacturer’s recommended attachments.
• Do not use with damaged cord or plug. If equipment is
not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return it to a service
center.
• Do not pull or carry by cord, use cord as a handle, close
a door on cord, or pull cord around sharp edges or
corners. Do not run equipment over cord. Keep cord
away from heated surfaces.
• Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
• Do not handle plug or equipment with wet hands.
• Turn off all controls before unplugging.
• Do not store, prepare or use solvent-containing
materials within a 5 m/16 feet radius of the mobile dryer.
• Flammable materials should not be placed close to a
drying device in use.
• Never direct the cassette towards highly combustible
materials.
• The dryer must not be exposed to paint fog, sanding
dust or solvents, due to fire and explosion risk.
Furthermore, the lifetime of the dryer will otherwise be
reduced.
• Allow for sufficient cooling time of the dryer.
• The mobile dryer is operated by highly dangerous
electrical voltage.
• Before accessing live parts, remove the main connector
from the wall socket. Only professional electricians may
have direct access into the electrical equipment.
• If the supply cord is damaged, it must be replaced by
the manufacturer,its service agent or similarly qualified
persons in order to avoid a hazard.
WARNING
Hot surface
The filter glass in front of the UV-lamp can become very
hot and has a long cooling down time after operation.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS