HeatSeal 625ES, Руководство по эксплуатации и обслуживанию

Страница: 5 / 16

5
Revised 2017
PRELIMINARY SETUP
INSTALLING & REPLACING AXLE ASSEMBLY

To install the axle assembly (1), simply position the assembly at the rear of the machine with the removable end cap (2) on
the left side as pictured below.

Insert two bolts (3) on each side through the holes in the machine base (4) and bearing blocks (5), screw on wing nuts (6)
and luster caps (7) to the ends of the screws

To replace the axle, remove cap (7) from end of one bolt and unscrew wing nut (6), then swing top bearing block away (8) to
release the axle assembly, unscrew removable cap (2), and replace film roll.
ADJUSTING FOR DIFFERENT WIDTH FILMS

Loosen the wing nuts and swing out upper bearing blocks on both sides.

Lift out the axle assembly, unscrew the movable end cap and position the fixed cap for film size being used and secure with
pin and o-ring (9).

Place the core of the film against the fixed cap (10), screw removable cap (2) in to film roll core and feed film from bottom of
roll (see film threading diagram below).
9
4
7
3
1
10
6
2
5
8
FILM THREADING DIAGRAM