HeatSeal 625ES, Руководство по эксплуатации и обслуживанию

Страница: 10 / 16

10
Revised 2017
Disassembling the Unit:
1. Turn off power and remove all power from machine and follow all local
safety procedures.
2. On the 107ES, remove rod that attaches the ES conversion kit from
the console legs, and two self tapping screws. Remove 4 pan head
Phillips screws that attached the electrical box. On 625ES, loosen
all four pan head Phillips screws, located at the top of the electrical
box - two in front, two in back, and remove the cover.
3. Unplug wires and remove wires from connections:

Remove the back six wires (labeled THERM 1 & 2, PEPI 1 & 2,
and LIGHT - & + on the board) from the green terminal connect-
or block (A) on the large circuit board with a flat head screw
driver.

Remove all four screws holding the large circuit board (B).

Locate the three shiny black wires (C) coming from the rocker
arm and remove the wires from their connections. One con-
nects to the bottom of the large circuit board and the other two
to slip on terminals for - all marked in picture 3.2 with blue
stickers.

Unscrew the green grounding wire (D) from the inside the box.

Separate the two wires being held by the wire nut (E).
4. Located under the machine, unscrew two hex head machine screws (F)
which connects the base stainless steel plate and rocker arm.
5. Pull the rocker arm assembly with wires out from the electrical box.
(If necessary, see page 2 Rocker Arm Parts Assembly)
Rewiring and Reassembling the Unit:
Reinstall rocker arm assembly in reverse order as on page 1.
Reconnect the wires (See page 3 for Timer Board close up):

Wire #7 should be matched with wire #7 from fuseholder and wire
nut together.

Wire #190 terminates to the top slot on front terminal board.

The two high luster wires—one goes to the neutral terminal board in
back and the other terminates under the large circuit board.

Non-terminal wires should be terminated into the green terminal
connector block (page 1 A) as follows:
- Thin black wire into “THERM 1 & 2”
- 22 gauge white wires into “PEPI 1 & 2”
- Wires #10 & #15 go into “LIGHT - & +”
A
D
E
F
B
E
C
C
C
3.2
5
3.1
625ES Shown
REPLACING ROCKER ARM ASSEMBLY