10
'O' rings
Plastic nut
(finger tight only)
Outlet pipe
Figure 10 – Fitting outlet spout
After choosing the correct site for the product, use
the backplate as a template and mark the two fixing
holes.
WARNING
BEWARE OF CABLES AND PIPES
WHICH MAY BE BURIED IN THE WALL.
Drill holes using a 6.5mm diameter masonry drill.
Use plugs to suit the wall and use the fixing screws
supplied.
6.2 Water connections
The outlet spout can be removed to ease installation.
The product has been designed for a 15mm water
pipe using the pushfit connection - see figure 13.
Decide where to connect the cold water mains feed
to the product. Ensure the pipe you have selected
is not a gas pipe or a hot water pipe. Chrome and
stainless steel pipe is not recommended.
An isolating stop valve MUST be incorporated to the
main water supply to comply with Water Regulations
- see figure 7.
Cut all necessary pipework to length with a pipecutter
and not a hacksaw. This will minimise the swarf and
prevent damage to the sealing o-ring in the pushfit
fitting - see figure 11 below.
Figure 11 – Cutting pipes
A clearance of at least 130mm above and below the
product should be allowed for access to the cover
screws.
Cable entry can be from the rear (preferred) or from
the bottom. The backplate has cut-out positions to
suit the size of the cable. When opting for bottom
entry make the cut- out to suit the cable before fitting
the backplate to the wall - see figure 8 below.
Make cut-out
using sharp
knife
Figure 8 – Bottom entry cable cut-out
6. Fitting Instructions
6.1 General
After reading the previous sections in this booklet
and choosing a good location for the product please
install, paying attention to the following plumbing,
electrical and commissioning sections.
TURN OFF the water and electrical supply.
The product is designed for bottom and rear entries
of water and electric cable. It is advisable to use the
rear entry (when it is possible), in order to obtain a
neater installation.
Unscrew the retaining screws and lift the cover from
the back plate - see figure 9 below.
Figure 7 Removing Cover
Figure 9 – Removing cover
Fit the outlet spout - DO NOT over tighten, finger
tight will be sufficient - see figure 10.
