Heatrae Sadia Aquatap Boil and Ambient, Инструкция по установке и эксплуатации

Страница: 19 / 36

19
11.0 USER INSTRUCTIONS
11.1 Once installed and commissioned, the filling and heating cycles of the Aquatap are
completely automatic.The indicator lights on the dispensing tap will indicate the status
of the system. If the “READY” light is flashing this indicates that the unit is
self-calibrating. The Aquatap will enter this mode after any period of the electrical
supply being switched off. DO NOT draw off water whilst the “READY” light is
flashing. When the “READY” light stops flashing and remains illuminated, the unit will be
ready to dispense boiling water.
11.2 Hot water drawn from the dispensing tap will at all
times be close to boiling point so due caution must
be taken when using the product, especially if it is
likely to be used by children, aged or infirm persons.
11.3 Hot water cannot be dispensed unless the safety
lock is turned off. The button marked “SAFETY”
should be pressed before the hot water dispensing
button.The dispensing button must be held in the
pressed position to continue dispensing. If it is
released, the “SAFETY” button must be pressed
again before more hot water can be dispensed.
If either the HOT button or CHILLED/AMBIENT button is pressed, the other button will
not activate.
11.4 Ambient/chilled water is dispensed by pressing the CHILLED/AMBIENT water
dispensing button. The safety button does not need to be pressed for dispensing
chilled/ambient drinking water.
11.5 In the unlikely event that the full store of hot water is completely drawn off from the
Aquatap, the pump will stop and flow from the dispenser will be interrupted. Should
this happen, the “READY” indicator will flash. After a few minutes, the unit will have
re-filled to a level where hot water can again be drawn off. This will be indicated by the
“READY” indicator remaining lit. If air becomes captive in the pump, operate the dispense
sequence to remove the air trapped in the pump. It does not indicate a fault with the
heater.
11.6 If the Aquatap is not used for a few days, the stored water may become “stale”. In
these instances it is advisable to draw off and discard the entire contents to flush
through the “stale” water. This will ensure that freshly boiled water is available for
dispensing.
11.7 Occasionally some scale residue may be drawn from the unit with the dispensed water
which could cause the water to appear “milky” for a short while. This is completely
harmless and will quickly clear if left to stand. Alternatively a few cups of water can be
dispensed and discarded until the water flows clearly.
BOILING WATER
LED
READY LED
FIGURE 14 : LED POSITIONS
SAFETY BUTTON
HOT WATER
DISPENSING BUTTON
CHILLED/AMBIENT
WATER DISPENSING
BUTTON
10.12 The commisioning record should be completed (see section 15.0, page 31).
10.13 These instructions should be left with the user for future reference.