Heatrae Sadia Aquatap Boil and Ambient, Инструкция по установке и эксплуатации

Страница: 13 / 36

13
8.4 Plug the dispensing tap cable connector into the Aquatap heater.
8.5 Plug the Aquatap into a 13A socket.
8.6 If a chiller unit is fitted to the dispenser, site the chiller near to the Aquatap heater, make
sure that the chiller level tube is facing outwards to allow servicing.
8.7 Connect the water supply to the chiller as per fig 8. The chilled water supply via a
6mm pipe from the chiller should be connected to the “cold outlet” side of the Aquatap, a
6mm to 10mm fitting is supplied for ease of use.
8.8 The dispenser tap chilled hose should be connected to the “outlet” pipe of the chiller unit
The dispenser tap ambient hose should be connected to the “outlet” of the Aquatap and
secured in place with the pipe clamps supplied.
ISOLATING
VALVE
CLAMP
HOT TAP
OUTLET
HOSE
FLEXIBLE
HOSE
MAINS
WATER
SUPPLY
TAP
VENT
HOSE
FIGURE 8: TAP MOUNTING (BOIL & CHILL)
CLAMP
DISPENSER CABLE
CHILLED WATER
SUPPLY
CHILLER
UNIT
1.5mm² 3 CORE HO5 VV-F
SHEATHED CABLE
TAP
CONNECTOR
WHITE HOSE
(NOTE: DRIP TRAY/SINK NOT SHOWN FOR CLARITY)
COLD TAP
OUTLET
HOSE 6mm
+ INSULATION
DISTANCE BETWEEN TAP AND HEATER
AS SHORT AS POSSIBLE TO ENSURE
CONNECTING PIPES RISE CONTIUOUSLY
3 BAR
PRESSURE REGULATOR
SUPPLIED
TEMP
SET
POWER
SWITCH
ICE BANK
LEVEL
INDICATOR
8mm PIPE
WATER IN
MINIMUM DISTANCE
BETWEEN UNITS
150mm