
26
Heatilator • Caliber Multi-Sided B-Vent • 4002-094 Rev H • 11/07
Latches
(bottom)
Glass
Assembly
Top Latches
(hooks)
Glass
Assembly
Figure 12.2 Glass Assembly
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
assembly removed, cracked, broken or
scratched.
• Replace glass assembly as a complete
assembly.
WARNING
I. Hood
The hood is to be located above the glass panel. The hood
must be attached or a
fi
re hazard may result. Locate the four
screws just inside the upper section of the appliance. Posi-
tion the hood and slide into position. Tighten the four screws.
See Figure 12.3.
Figure 12.3 Installing the Hood
H. Grilles and Trim
• Install optional marble and brass trim surround kits using
the installation instructions included with them.
• Marble, brass, brick, tile or other non-combustible
materials can be used to cover the gap between sheet
rock and appliance.
• Do not obstruct or modify the air inlet/outlet grilles.
• Leave space to lower the bottom grille and remove the
trim door.
G. Glass Assembly
Removing Glass Assembly
• Remove
fi
rescreen.
• Pull the four (30/33/36 in. appliances) or seven (42 in.
appliance) glass assembly latches out of the groove on
the glass frame.
• Remove the glass panel from the appliance.
Replacing Glass Assembly
• Set the glass panel on the lower two or four glass assembly
latches, ensuring the glass panel is centered in the
opening.
• Pull out and latch all four or seven glass assembly latches
into the groove on the glass frame.
• Replace
fi
rescreen.
J. Air Shutter Setting
Model
NG
LP
GBFL36 Series
GBCR36 Series
GBCL36 Series
GBST36 Series
Closed
Open