18
Hearth & Home Technologies • CNXT70PLUS • 4034-105 Rev C • 09/05
Figure 8.6
Junction Box
F. Junction Box Installation
If the box is being wired from the
OUTSIDE
of the appliance:
• Remove the cover plate located on the outer shell - right side (see Figure 8.5).
• Install the supplied Romex™ connector in the cover plate.
• Feed the necessary length of wire through the connector.
• Make all necessary wire connections and reattach the cover plate to the outer shell.
If the box is being wired from the
INSIDE
of the appliance:
• Remove the screw attaching the junction box/receptacle to the outer shell, rotate the junction box inward to disengage
it from the outer shell (see Figure 8.5).
• Pull the electrical wires from outside the appliance through this opening into the valve compartment.
• Feed the necessary length of wire through the connector.
• Make all necessary wire connections to the box/receptacle and reassemble the box/receptacle to the outer shell.
WHT
WHT
BLK
BLK
GRN wire
inside box
Copper
ground attached
to GRN screw with
GRN wire
14/2WG
Cover Plate
outside firebox
Romex
Connector
Figure 8.5
Junction Box Detail
Содержание CNXT70PLUS
Страница 16: ...16 Hearth Home Technologies CNXT70PLUS 4034 105 Rev C 09 05 Figure 8 3 Appliance Circuit Board Wiring...
Страница 23: ...Hearth Home Technologies CNXT70PLUS 4034 105 Rev C 09 05 23 B Lighting the Appliance...
Страница 29: ...34 Hearth Home Technologies CNXT70PLUS 4034 105 Rev C 09 05 This page intentionally left blank...
