Heatilator • ADI-ZC-FB • 2032-900 Rev. E • 8/05
15
!
Figure 8. Junction box installation
WARNING: USE OF THE CORD SUPPLIED WITH
THE J-BOX IS REQUIRED.
Optional Accessories
Use of the electrical junction box provided is required if
using a blower or remote. Plug the cord into a convenient
outlet. An electrician may install an outlet box inside the
fireplace. Place the outlet in the lower, back corner of the
fireplace. Make sure fan doesn’t touch back wall.
FEED PLUG
THROUGH HOLE
INSERT RELIEF
AROUND CORD IN THIS END
FROM OUTSIDE OF UNIT
JUNCTION
BOX
SIDE
WALL
Figure 10.
RUBBER
GROMMETS
FAN
ATTACH
GROUND
WIRE
COVER
PLATE
Fan Option
This product accepts an optional blower GFK-160A. Instal-
lation of this blower requires 110 VAC power supplied to the
Figure 9. Fan Wiring Diagram
NOTE:
If any of the original wire as supplied with the appli-
ance must be replaced, it must be replaced with type 105
0
crated wire.
NOTE:
Do NOT install blower if using operable glass doors.
JUNCTION BOX
VARIABLE SPEED CONTROL
TEMPERATURE
SENSOR SWITCH
WHT
GRN
BLK
BLK
110-120 VAC
BLOWER
BLOWER RECEPTACLE
BLK
BLK
BLK
BLK
WHT
GROUND
WHT
BLK
BLK
BLK
REMOTE
RECEPTACLE
SPEED CONTROL
(RHEOSTAT)
JUNCTION
BOX
FAN
TEMPERATURE
SENSOR SWITCH
BEND UP
TABS
FAN
OUTLET
REMOTE
OUTLET
INSERT STUD THROUGH HOLE
AND SECURE WITH WING NUT
WING
NUT
TEMP SWITCH
BRACKET
electrical junction box. The optional blower GFK-160A CAN-
NOT be used when using operable glass doors.
On units already installed removal of decorative front, sur-
round and gas insert is required.
• Detach flexible liner from back of unit.
• Remove the four screws on the coverplate (see Figure 10).
• Bend up the tabs on the base pan (see Figure 9).
• Place the blower in between the bend up tabs.
• Install and wire the blower per instructions shipped with
the fan. Refer to Figure 9 for placement of the temp switch
bracket and mounting stud.
• The ground wire of the fan can clip on the side of the
base pan.
• Attach rubber grommets to cover plate as shown (in-
cluded in manual bag assembly).
• Reinstall the cover plate on the unit. Make sure the fan
does not make contact with the back wall.
