Heat Link PEX-a, Руководство по установке

Страница: 32 / 44

32
®
Link Heat
Link
Pure
®
Link
Plus
Link
Pure
®
Link
Plus
Link
Pure
®
Link
Plus
1/2"
®
Heat Link
1/2"
®
Heat Link
1/2"
®
Heat Link
1. Open the jaws (squeeze at the
points indicated in the diagram)
and position squarely around
the sleeve, then allow the jaws to
firmly grasp the sleeve.
2. Squeeze the trigger until the
press is complete.
Note: if the red LED flashes
or there is an audible beep,
consult “Tab. 1” of the tool
instructions.
3. Open the jaws and remove the
tool from the sleeve.
Power Press Tool with Pistol Grip Instructions
For complete power tool instructions, refer to the instruction booklet (L611600) that comes
with the tool.
1⁄2" to 1 1⁄2" Press Instructions; Auto Press
{
{
Never press with empty jaws as this will damage the jaws.
{
{
Regularly check tool jaws and sleeve for any abnormalities that could be an indication of a
damaged tool.
{
{
If the Stainless Steel Sleeve is damaged or pressed incorrectly, both the fitting and the sleeve
must be replaced.
{
{
Never reuse stainless steel press sleeves.
4. Inspect the connection to ensure the tubing is still properly seated (only PEX is visible
in sleeve cut out), and the press has been properly formed onto the sleeve (see diagram
for guideline). Tool jaws imprint "HL" on the sleeve. An improperly positioned tool may
result in a poor press and a damaged fitting.
Sight
Hole
Improperly
positioned
jaws
PEX
improperly
seated in
sleeve